2022 Latest 350-601 Exam Dumps Recently Updated 282 Questions [Q48-Q65]

Share

2022 Latest 350-601 Exam Dumps Recently Updated 282 Questions

Cisco 350-601 Real 2022 Braindumps Mock Exam Dumps

NEW QUESTION 48
Refer to the exhibit. What is the result of executing this python code?

  • A. It sends the switch configuration to Cisco TAC.
  • B. It schedules a backup on a Cisco switch using EEM.
  • C. It backs up Cisco switches to Cisco Prime infrastructure.
  • D. It sends a Cisco device backup to a remote destination.

Answer: D

 

NEW QUESTION 49
What are two types of FC/FCoE oversubscription ratios? (Choose two.)

  • A. port bandwidth to uplink bandwidth
  • B. switch processing power to end-node processing power
  • C. host bandwidth to storage bandwidth
  • D. server storage to end-node count
  • E. edge ISL bandwidth to core ISL bandwidth

Answer: C,E

Explanation:
Section: Storage Network

 

NEW QUESTION 50
A network engineer must perform a backup and restore of the Cisco Nexus 5000 Series Switch configuration. The backup must be made to an external backup server. The only protocol permitted between the Cisco Nexus switch and the backup server is UDP. The backup must be used when the current working configuration of the switch gets corrupted. Which set of steps must be taken to meet these requirements?

  • A. 1 Perform a startup-config backup to an FTP server.
    2 Copy startup-config in the boot flash to the running-config file
  • B. 1 Perform a running-config backup to an SFTP server
    2 Copy backup-config from the SFTP server to the running-config file
  • C. 1 Perform a running-config backup to an SCP server
    2 Copy running-config in the boot flash to the running-config file
  • D. 1 Perform a startup-config backup to a TFTP server
    2 Copy backup-config from the backup server to the running-config file

Answer: D

Explanation:
TFTP is the only protocol that uses UDP. FTP, SFTP, and SCP use TCP.

 

NEW QUESTION 51
A storage engineer must configure zoning on a Cisco MDS 9000 Series switch. Drag and drop actions from the left into the order on right

Answer:

Explanation:

Explanation
A, B, F, D, C, E

 

NEW QUESTION 52
An engineer must configure OSPFv2 connectivity between a pair of Cisco Nexus switches. The connection between the switches must meet these requirements:
* Use unicast for updates.
* Use decentralized communication of updates.
* Full adjacency between switches.
Which configuration is needed to meet these requirements?

  • A. interface with a type of p2p network
  • B. virtual link between the neighbors
  • C. stub area between the neighbors
  • D. filter list between the neighbors

Answer: A

 

NEW QUESTION 53
An engineer must shut down the Ethernet 1/2 interface when the Ethernet 4/5 interface state is down. Drag and drop the CLI commands from the bottom onto the blanks in the exhibit to implement this EEM. Not all commands are used.

Answer:

Explanation:

 

NEW QUESTION 54
Refer to the exhibit.

What is the result of implementing this configuration?

  • A. The Fibre Channel interface is configured for synchronization distribution.
  • B. The Fibre Channel interface is configured for SPAN.
  • C. The Fibre Channel interface is configured for source distribution.
  • D. The Fibre Channel interface is configured for FSPF.

Answer: B

Explanation:
Section: Storage Network

 

NEW QUESTION 55
An engineer is configuring VNTag between a virtualized server and a Cisco Nexus 5500 Series switch. Drag and drop the configuration steps from the into the correct order on the right.

Answer:

Explanation:

 

NEW QUESTION 56
Refer to the exhibit.

An engineer configures a new application profile using REST API and receives this error massage. Which method can be used before application profile can be configured?

  • A. POST to aaaLogout
  • B. POST to aaaLogin
  • C. GET to aaaListDomains
  • D. POST to aaaRefresh

Answer: B

Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/rest_cfg/2_1_x/ b_Cisco_APIC_REST_API_Configuration_Guide/ b_Cisco_APIC_REST_API_Configuration_Guide_chapter_01.html

 

NEW QUESTION 57
The Cisco Nexus switch Generic Online Diagnostics policy for a PortLoopback test requires 10 consecutive failures to error disable the port. The customer wants to change it to 5 consecutive failures. Which configuration applies the changes for module 1 only?

  • A. Option C
  • B. Option B
  • C. Option A
  • D. Option D

Answer: D

Explanation:
Explanation
"mod all" is incorrect. "mod 1test" is incorrect. "publish event" is incorrect.
"mod 1 test" is correct. It is with "policy-default".

 

NEW QUESTION 58
Refer to the exhibit.

Service degradation is reported on a VM that is deployed on a Cisco UCS blade server. The traffic from the vNIC is required to SPAN in both directions to a packet analyzer that is connected to UCS-A slot 2 port 12.
Which two commands are needed to complete the configuration? (Choose two.)

  • A. UCS-A /eth-traffic-mon/fabric/eth-mon-session* # create eth-mon-session/dest-interface 2 12
  • B. UCS-A /eth-traffic-mon/fabric/eth-mon-session # activate
  • C. UCS-A /org/service-profile/vnic/mon-src* # set direction receive transmit
  • D. UCS-A /org/service-profile/vnic/mon-src* # set direction both
  • E. UCS-A /eth-traffic-mon/fabric/eth-mon-session' # create dest-interface 2 12

Answer: D,E

 

NEW QUESTION 59
Host 1 is in VLAN 100 located is DataCenter 1 and Host2 is in VLAN200 located in DataCenter2. Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts?

  • A. Option B
  • B. Option D
  • C. Option C
  • D. Option A

Answer: A

 

NEW QUESTION 60
Refer to the exhibit.

Which action must be taken before the maintenance policy can be committed?

  • A. Specify a maintenance time by selecting a schedule.
  • B. Associate a service profile to the maintenance policy.
  • C. Set the policy to apply the change on the next reboot.
  • D. Set the soft shutdown timer to a specific time.

Answer: A

 

NEW QUESTION 61
An engineer has a primary fabric that is named UCS-A and a secondary fabric that is named UCS-B. A certificate request that has a subject name of sjc2016 for a keyring that is named kr2016 needs to be created.
The cluster IP address is 10.68.68.68. Which command set creates this certificate request?
A)

B)

C)

D)

  • A. Option C
  • B. Option D
  • C. Option B
  • D. Option A

Answer: A

Explanation:
Explanation

 

NEW QUESTION 62
APIC EPG Resolution Immediacy is set to "Immediate".
Which statement is true about the Deployment Immediacy for VMM domains associated to EPGs?

  • A. The "Immediate" and "On demand" options require a port group to be created on the VDS.
  • B. If "On demand" is selected, the policy is programmed in the hardware only when the APIC detects a VM created in the EPG.
  • C. If "On demand" is selected, the policy is programmed in the hardware only when the first packet is received through the data path.
  • D. If "Immediate" is selected, the policy is programmed in the hardware as soon as the leaf is booted.

Answer: C

Explanation:
Section: Network

 

NEW QUESTION 63
Refer to the exhibit.

What is configured as a result of running these commands?

  • A. strict unicast RPF
  • B. reverse lookup for outbound packets
  • C. loose unicast RPF
  • D. IP Source Guard

Answer: A

 

NEW QUESTION 64
A customer has a requirement for an automation solution that supports periodically acquiring configuration from a centralized server and aligning UCS servers to their desired state. Which open-source tool meets these requirements?

  • A. Kubemetes
  • B. Puppet
  • C. Terraform
  • D. SaltStack

Answer: B

Explanation:
"Overview of Puppet architecture: [...] After it receives a catalog, the Puppet agent applies the catalog by checking each resource that the catalog describes. If it finds any resources that are not in their desired state, it makes any changes necessary to correct them."
https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rackservers/ whitepaper_c11-740103.pdf
https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-devops-integration-sol-brief.pdf from DCCOR book under Puppet section The operation of the Puppet agent involves periodically connecting to the Puppet master, which in turn compiles and sends a configuration manifest to the agent. The agent reconciles this manifest with the current state of the node and updates state that is based on differences.

 

NEW QUESTION 65
......

Verified 350-601 Exam Dumps Q&As - Provide 350-601 with Correct Answers: https://testking.exams-boost.com/350-601-valid-materials.html